Priming A Coil – Why And How You Should Do It

Priming A Coil - Why And How You Should Do It

If you’re a user of a pod mod or a vape pen, you may very well be accustomed to certain ease of use when it comes to vaping. These devices are very efficient and require little set-up or care from a vaper on account of their inbuilt coils, wicking cotton and tanks. Many e-liquid wholesale distributors in the UK actually design their juices around low powered batteries and devices.  

Whilst these vape devices may seem simple on paper, there’s a whole universe of e-cigs that require a little more attention from their users. These are devices that are built with rebuildable decks in mind. These devices require users to replace and install their own atomisers and coils which whilst a little tricky at first, is actually quite easy to get your head around. If you’re a vaper who is thinking of upgrading their device to accommodate for sub-ohm e-liquids such as those sold by vape liquid wholesale UK companies, then this blog will outline all the information you need about atomisers, how they work and how to prime them properly.

What Is A Coil?

Whilst the word coil might commonly refer to the wire within your vape device, the replaceable coil actually refers to both this wire, atomiser and wicking cotton. This is essentially where your e-liquid is heated up by the battery, saturated into the cotton and turned into vapour. Coils such as the Aspire Cleito Coil are the main organ of your vape device’s body and without it, it would be little more than a hollow shell.

What Vape Devices Need An Atomiser And Coil?

Replaceable coils such as the UK’s Smok Nord coil are most commonly required for variable devices. These can include variable wattage and voltage devices, mech mods with entirely customisable circuit decks and temperature control vape devices. 

Why You Need To Prime A Coil?

Coils should be primed when first installed as they will need to be “broken in” so to speak. If you use your coil without priming it first, it might end in your burning the wire or wicking cotton and a nasty burnt taste that could damage your coil. Every time you buy a new coil, which you should do so every two weeks to one month depending on the regularity of your vaping habits. 

How To Prime A Coil

So, down to the business of coil priming. For the best results, it’s definitely worth being generous with how much e-liquid you drip on your coil. In fact, you’ll want to see the cotton between the holes on the side of the body of the coil become wet and saturated. Give the coil time to soak in the e-liquid between drips before flicking it on the side to get rid of any excess.

Once you’ve saturated the wicking cotton, refit your coil and fill the tank of your vaporiser with e-liquid. Wait for 5 minutes or so to ensure that the e-liquid is fully soaking through the atomiser. 

Use the mouthpiece to take some priming puffs as if you were vaping, but make sure not to hit the fire button, this will further help the e-liquid travel through the coil once you’ve done this, turn your device to the lowest power possible (if it has variable capabilities), and press the fire button. Work the power up as you vape until you find the right temperature. All the while, your device will be adjusting to its new coil.